22 ACH550 Installation, Operation and Maintenance Manual
ACH550-UH
Operating the drive
AUTO/HAND – The very first time the drive is powered up, it is in the auto control
(AUTO) mode, and is controlled from the Control terminal block X1.
To switch to hand control (HAND) and control the drive using the control panel, press
and hold the or button.
• Pressing the HAND button switches the drive to hand control while keeping the
drive running.
• Pressing the OFF button switches to hand control and stops the drive.
To switch back to auto control (AUTO), press and hold the button.
Hand/Auto/Off – To start the drive press the HAND or AUTO buttons, to stop the
drive press the OFF button.
Reference – To modify the reference (only possible if the display in the upper right
corner is in reverse video) press the UP or DOWN buttons (the reference changes
immediately).
The reference can be modified in the local control mode (HAND/OFF), and can be
parameterized (using Group 11 reference select) to also allow modification in the
remote control mode.
Note: The Start/Stop, Shaft direction and Reference functions are only valid in local
control (HAND/OFF) mode.
Start-up by using the Start-Up Assistant
To start the Start-Up Assistant, follow these steps:
The Start-Up Assistant will guide you through the start-up.
1
Select MENU to enter the main menu.
2
Select ASSISTANTS with the Up/Down
buttons and select ENTER.
3
Scroll to COMMISSION DRIVE with the
Up/Down buttons.
4
Change the values suggested by the
assistant to your preferences and then
press SAVE after every change.
To Next Page
Loading...
Need help?
General
