Parameters 65
Summary of parameter groups
Group Contents Page
01 Actual values Basic signals for monitoring the drive. 67
03 Input references Values of references received from various sources. 70
04 Warnings and faults Information on warnings and faults that occurred last. 71
05 Diagnostics Various run-time-type counters and measurements related to drive
maintenance.
71
06 Control and status words Drive control and status words. 74
07 System info Drive hardware and firmware information. 77
10 Standard DI, RO Configuration of digital inputs and relay outputs. 78
11 Standard DIO, FI, FO Configuration of the frequency input. 82
12 Standard AI Configuration of standard analog inputs. 84
13 Standard AO Configuration of standard analog outputs. 88
21 Start/stop mode Start and stop modes. 93
23 Speed reference ramp Speed reference ramp settings (programming of the acceleration
and deceleration rates for the drive).
96
24 Speed reference
conditioning
Speed error calculation; speed error window control configuration;
speed error step.
97
25 Speed control Speed controller settings. 97
28 Frequency reference chain Settings for the frequency reference chain. 101
30 Limits Drive operation limits. 102
31 Fault functions Configuration of external events; selection of behavior of the drive
upon fault situations.
106
32 Supervision Configuration of signal supervision functions 1…6. 114
35 Motor thermal protection Motor thermal protection settings such as temperature
measurement configuration, load curve definition and motor fan
control configuration.
120
36 Load analyzer Peak value and amplitude logger settings. 127
40 Process PID set 1 Parameter values for process PID control. 130
46 Monitoring/scaling settings Speed supervision settings; actual signal filtering; general scaling
settings.
140
49 Panel port communication Communication settings for the control panel port on the drive. 142
50 Fieldbus adapter (FBA) Fieldbus communication configuration. 143
51 FBA A settings Fieldbus adapter A configuration. 146
52 FBA A data in Selection of data to be transferred from drive to fieldbus controller
through fieldbus adapter A.
147
53 FBA A data out Selection of data to be transferred from fieldbus controller to drive
through fieldbus adapter A.
148
58 Embedded fieldbus Configuration of the embedded fieldbus (EFB) interface. 148
79 Start stop control Start - stop control configuration parameters. 155
80 Flow calculation Defines flow calculation parameters.
82 Pump protections
Settings for dry run protection.
83 Pump cleaning Settings for the pump cleaning sequence.
95 HW configuration Various hardware-related settings. 162
ACQ80 FW.book Page 65 Thursday, February 14, 2019 11:33 AM
To Next Page
Need help?
General
