4.2.2 TCP/IP Local Connection
Material Required:
• Ethernet Cross-Over Cable (see Figure 4-3
).
4.2.2.1 Instructions
1) Make local connection to the NGC using either a USB or RS-232 cable to
set up the initial parameters.
Figure 4-3 Ethernet Cable-Cross-Over
2) From the Analyzer Operation screen in PCCU, click Show Tree View in the
upper left corner of screen.
3) Click Communications to show the communication setup screen.
4) Select the Network tab. Enable DHCP. Send changes, and record a new IP
address for later use.
5) Exit PCCU, and disconnect the local communication cable.
6) Connect the Ethernet cross-over cable between the PC and NGC.
7) Open PCCU software. Click Operate on the menu bar. Navigate through the
drop-down list to Setup. From the fly-out menu, select System Setup.
8) Under Communications, set the PCCU com port to TCP, and enter the IP
address previously noted in the network ID or IP box. Close the System Setup
screen.
9) Verify the TCP/IP communications by clicking the Entry button on the main
screen (upper most left button).
8
7
6
5
4
3
2
1 8
7
6
5
4
3
2
1Not Used
RX-
RX+
TX
-
TX+
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
Not Used
TX
+
TX-
RX+
RX-
8
7
6
5
4
3
2
1
Orange
/
White
8
7
6
5
4
3
2
1
Orange
Green/
White
Blue
Blue/White
Green
Brown/White
Brown
Orange
Green
Orange
/White
Green/White
Blue/
White
Blue
Brown/White
Brown
Crossed-
Over Cable
Connector Clip
End View
8
1
To Next Page
Loading...
Need help?
General
