Figure 6-1 Troubleshooting Flowchart
6.2 Start-Up Diagnostic Troubleshooting
This section focuses on determining what has caused an alarm during start-up
diagnostics. The Totalflow
®
NGC8200 has an extensive built-in list of tests which
are performed each time the unit is started. This start-up testing may be disabled,
but Totalflow recommends that it be left enabled.
The diagnostics consist of 4 areas of testing:
• Carrier Pressure Regulator Test
• Oven Temperature Test
• Processor Control Test
• Stream Test
The start-up tests may also be performed on a regular schedule. See the PCCU
help files for more information on scheduling diagnostics.
Return to
Start
Return to
Start
Return to
Start
Still Having
Trouble?
YES
NO
START
Batteries
Dead?
Go To
COMM
Troublelshooting
Chart
Call Totalflow
Technical
Support
YES
NO
Return to
Start
END
Receive
Alarm?
YES
NO
During
Startup?
YES
NO
Go To
Startup
Diagnostics
Go To
Troubleshooting
Alarm
COMM
Trouble?
YES
NO
Go To
Power Supply
Troubleshooting
Chart
To Next Page
Loading...
Need help?
General
