ABB RET670 User Manual

11.6.11.4 Generic measured value MVGGIO
Main menu/Test/Function status/Monitoring/GenericMeasuredValue(GGIO)/
MVGGIO:x
Displays the analog output from the MVGGIO block. The value shown here
depends on the settings and the logical configuration of the preprocessing blocks.
The measurement displayed may be current, voltage, frequency, phase angle etc.
11.6.11.5 Global positioning system
Main menu/Test/Function status/Monitoring/GPS
Displays the number of satellites supplying positioning and timing data to the GPS
module.
11.6.11.6 IEC61850 generic communication I/O functions 16 inputs SP16GGIO
Main menu/Test/Function status/Monitoring/IndicationBits(GGIO)/
SP16GGIO:x
Displays the output data of the SP16GGIO function.
11.6.11.7 LEDs
Main menu/Test/Function status/Monitoring/LEDs/Start and trip LEDs
Displays the status of start and trip LEDs.
Main menu/Test/Function status/Monitoring/LEDs/All indication LEDs
Shows new and accumulated indications and the status of the HMI indication LEDs.
11.6.11.8 Measured value expander block RANGE_XP
Main menu/Test/Function status/Monitoring/MeasValExpander/
RANGE_XP:x
Displays available instances of the function block RANGE_XP. These show the
boolean values assigned to the integer values generated by analog inputs.
11.6.11.9 IEC61850 generic communication I/O functions SPGGIO
Main menu/Test/Function status/Monitoring/SinglePointIndication(GGIO)/
SPGGIO:x
Displays the output data of the SPGGIO function.
Section 11 1MRK504114-UEN E
Test the IED
94
Operator's manual

ABB RET670 Specifications

General

Rated Frequency	50/60 Hz
Inputs	Analog and binary inputs
Application	Protection of power systems
Communication Protocols	IEC 61850, DNP3, Modbus
Operating Temperature Range	-25°C to +55°C
Mounting	Rack mounted
Number of Binary Inputs	Up to 48
Number of Binary Outputs	32
Protection Functions	Overcurrent Protection
Outputs	Binary outputs
Enclosure	IP 54
Type	Line Differential Protection