Section 8 Handle disturbances
About this chapter
This chapter describes disturbance detection and handling. This includes resetting
LED alarms, triggering disturbance reports and the viewing of several fault indicators.
8.1 Identify a disturbance
A disturbance record can be generated manually by using the Manual Trig
functionality in the HMI menu. Other disturbance records are generated
automatically in the system dependant on the settings made. Disturbance reports
generate a disturbance sequence number and are time tagged. The fault location
and fault loop are among the data generated in a fault record. Under each fault
report there are five categories of information available. These are described in the
sections that follow.
8.2 View disturbance record details
8.2.1 View general information
By choosing General information after selecting a disturbance record in the list of
disturbance records the screen generated displays information about the
disturbance such as its sequence number, time of occurrence, trig-signal, fault
location and fault loop. The path in the HMI is shown below.
Main menu/Disturbance records/Manual trig
8.2.2 View disturbance indications
The Indications section of a disturbance record displays the recording number and,
the time and date of the disturbance. The path in the HMI is shown below.
Main menu/Disturbance records/Record xx/Indications
8.2.3 View event recordings
The Event recording section in the Disturbance report shows the recording number.
The path in the HMI is shown below.
1MRK504114-UEN E Section 8
Handle disturbances
39
Operator's manual
To Next Page
Loading...
Need help?
General
