voltage is 3U0, for positive sequence voltage is U1 and for negative sequence
voltage is U2.
There are sets of settings with some categories of parameter settings per set
instance of VMSQI
9.2.7.7 Disturbance report DRPRDRE
Main menu/Settings/General Settings/Monitoring/Disturbance Report/
DisturbanceReport(RDRE)
Displays available settings.
Binary signals
Main menu/Settings/General settings/Monitoring/Disturbance report/Binary
signals(RBDR)/Channel xx-yy
There are some groups of several channels with several binary outputs per channel.
Each channel has some settable parameters. These are operation, trig level,
indication MA and set LED.
Analog signals
Main menu/Settings/General settings/Monitoring/Disturbance report/Analog
signals(RADR)/Channel xx-yy
There are some groups of a number of channels with a number of analog signals
per channel. Each signal has some settable parameters such as operation, Nominal
value and trig values.
9.2.7.8 Generic measured value MVGGIO
Main menu/Settings/General Settings/Monitoring/
GenericMeasuredValue(GGIO)/MVGGIO:x
Displays available instances of settings for the Measured value function MVGGIO
with a number of settable parameters. These settings are used to define the range of
values used in the function block and to set the threshold values. This is a generic
function and therefore the input values depend on the application.
9.2.7.9 Event function
Main menu/Settings/General settings/Monitoring/EventFunction/EVENT:x
The Event function menu consists of several sets of settable parameters EVENT
where the SPA channel mask, LON channel mask, Event mask and minimum
repetition interval can be set.
Section 9 1MRK504114-UEN E
Read and change settings
54
Operator's manual
To Next Page
Loading...
Need help?
General
