AERMEC HMI-BHP User Manual

7
2.4 COMMISSION (FUNCTION)
Page Content Paragraph
1
Ctrl.state
7.2Setting the control logic (Ctrl.state)p.19
Cool 2-Way valve
7.3Setting the status of the 2-way valve in cooling mode (Cool 2-Way
valve)p.19
Heat 2-Way valve
7.4Setting the status of the 2-way valve in heating mode (Heat 2-Way
valve)p.20
Solar setting 7.5Setting solar system integration (Solar setting)p.20
Water tank
7.6Set the installation of a compatible Aermec accessory tank (DHW
tank)p.20
2
Thermostat
7.7Setting the use of an external thermostat (Thermostat)p.20
Other thermal 7.8Setting an additional heat source (Other thermal)p.20
Optional E-heater 7.9Setting an additional heater (Optional E-heater)p.21
Ambient sensor
7.10Setting the installation of the remote room temperature probe
(Ambient sensor)p.22
Air removal 7.11Setting the air purging function (Air removal)p.22
3
Floor debug
7.12Setting the pre-heating procedure for radiant panels (Floor de-
bug)p.22
Manual defrosting 7.13Activating the defrost cycle (Manual defrost)p.22
Force mode 7.14Activating mode forcing (Force mode)p.23
External contact 7.15Activating auxiliary device management (Gate-Ctrl)p.23
Current limit 7.16Setting of max. absorption (A/P limit)p.23
4
Address
7.17Setting the serial address of the unit (Address)p.23
Refri. recovery 7.18Setting the refrigerant recovery function (Refri. recovery)p.23
Tank heater
7.19Set the management logic for the compatible Aermec accessory
tank heater (elec. tank heater)p.24
Memory contact 7.20Set the memory contact function (Memory contact)p.24
2.5 COMMISSION (PARAMETER)
Page Content Paragraph
1
T HP max
7.21Setting the maximum temperature for the DHW storage tank via
heat pump only (T HP max)p.24
Cool run time 7.22Setting the cooling operating time (Cool run time)p.24
Heat run time 7.23Setting the heating operating time (Heat run time)p.24
2.6 GENERAL
Page Content Paragraph
1
Temp. unit
8.2Setting the unit of measurement (Temp. unit)p.25
On/o memory 8.3Activating/deactivating the memory (On/o memory)p.25
Beeper 8.4Activating/deactivating the sound (Beeper)p.25
Back light 8.5Setting the display lighting (Back light)p.25
Time&Date 8.6Setting the system date and time (Time&Date)p.25
2
Language
8.7Selecting the system language (Language)p.26
WiFi 8.8Activating the WiFi (WiFi)p.26

AERMEC HMI-BHP Specifications

General

Brand	AERMEC
Model	HMI-BHP
Category	Controller
Language	English