Rockwell Automation Publication 22C-UM001J-EN-E - January 2017 49
Start Up Chapter 2
Viewing and Editing
Parameters
The last user-selected Basic Display Group parameter is saved when power is
removed and is displayed by default when power is reapplied. The following is
an example of basic integral keypad and display functions. This example
provides basic navigation instructions and illustrates how to program the first
Basic Program Group parameter.
Step Key(s) Example Displays
1. When power is applied, the last user-selected
Basic Display Group parameter number is
displayed with flashing characters. The display
then defaults to that parameter’s current
value. (Example shows the value of b001
[Output Freq] with the drive stopped.)
2. Press the Up Arrow or Down Arrow to scroll
through the Basic Display Group parameters.
(Only in Display Groups)
or
3. Press Esc once to display the Basic Display
Group parameter number shown on power-
up. The parameter number will flash.
4. Press Esc again to enter the group menu. The
group menu letter will flash.
5. Press the Up Arrow or Down Arrow to scroll
through the group menu (b, P, T, C, A and d).
or
6. Press Enter or Sel to enter a group. The right
digit of the last viewed parameter in that
group will flash.
or
7. Press the Up Arrow or Down Arrow to scroll
through the parameters that are in the group.
or
8. Press Enter or Sel to view the value of a
parameter. If you do not want to edit the
value, press Esc to return to the parameter
number.
or
9. Press Enter or Sel to enter program mode to
edit the parameter value. The right digit will
flash and the Program LED will illuminate if
the parameter can be edited.
or
10.If desired, press Sel to move from digit to digit
or bit to bit. The digit or bit that you can
change will flash.
11.Press the Up Arrow or Down Arrow to change
the parameter value.
or
12.Press Esc to cancel a change. The digit will stop
flashing, the previous value is restored and the
Program LED will turn off.
Or Press Enter to save a change. The digit will
stop flashing and the Program LED will turn
off.
13.Press Esc to return to the parameter list.
Continue to press Esc to back out of the
programming menu.
If pressing Esc does not change the display,
then b001
[Output Freq] is displayed. Press
Enter or Sel to enter the last group menu
viewed.
The Basic Program Group (page 61
) contains the most commonly changed parameters.
To Next Page
Loading...
Need help?
General
