Rockwell Automation Publication 6000-UM002E-EN-P - April 2018 41
Setup and Operation Chapter 3
Operation Bar
Setup and Monitor Box
The set frequency field is the only one which is user-configurable. See Set
Frequency (Hz) for instruction on how to set the frequency.
Table 6 - Operation Bar Buttons
Start Starts the drive only if no fault is found during self test at startup; otherwise, this button is invalid
Accel Increases the frequency by the set step
Decel Decreases the frequency by the set step
Stop Stop output of the drive
Reset
(1)
(1) The drive must not be running to complete this operation.
Resets the drive (under fault conditions) once
Table 7 - Monitoring Parameters
Set Frequency Frequency set for the drive (Hz)
Actual Frequency Actual frequency of the drive (Hz)
Motor Speed Speed of the motor (%)
Motor Voltage Voltage of the motor stator (V)
Motor Current Current of the motor stator (A)
To Next Page
Loading...
Need help?
General
