Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017 13
Preface
This manual provides information about the dual-port, built-in EtherNet/IP
interface in PowerFlex® 755T drives and bus supplies, and how to use it for
network communication.
To order paper copies of documentation, contact your local Allen-Bradley
distributor or Rockwell Automation® sales representative.
To find your local Allen-Bradley distributor or sales representative, visit http://
www.rockwellautomation.com/locations.
For information, such as firmware updates or answers to drive-related
questions, go to the Drives Service and Support website at http://
www.ab.com/support/abdrives and click the Downloads or Knowledgebase
link.
Conventions Used in This
Manual
These conventions are used throughout this manual:
Parameter names are shown in the format Device Parameter xxx - [*] or Host
Parameter xxx - [*]. The xxx represents the parameter number. The *
represents the parameter name—for example, Device Parameter 01 -
[Operating Mode].
• Where a parameter is referenced outside of the native port, it is
referenced as Port#:Parameter# [parameter name]
(0:301 - [Net Addr Scr] or 10:350 - [Vref Source])
• The dialog box images in this manual resulted from using this software:
– RSLinx® Classic software, version 2.52
– RSLogix 5000® software, version 20, for Automatic Device
Configuration (ADC) information
– Studio 5000™ environment, version 21 or later, for Automatic Device
Configuration (ADC) information
Different versions of the software can have dialog boxes that vary in
appearance, and differences in procedures.
Additional Resources
These documents contain additional information concerning related products
from Rockwell Automation.
Resource Description
PowerFlex 750-Series Products with TotalFORCE Control
Installation Instructions, publication 750-IN100
Provides the basic steps to install PowerFlex 755TL
low harmonic drives, PowerFlex 755TR regenerative
drives, and PowerFlex 755TM drive systems.
PowerFlex 755TM IP00 Open Type Kits Installation
Instructions, publication 750-IN101
Provides instructions to install IP00 Open Type kits in
user-supplied enclosures.
To Next Page
Loading...
Need help?
General
