30 Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017
Chapter 2 Configure the Interface
Apply Power
1. Close the cabinet door for the drive.
2. Apply power to the drive.
The built-in EtherNet/IP interface receives its power from the drive.
3. Check the status indicators either by using status parameters, HIM
status, or the software tool status.
When you apply power to the built-in EtherNet/IP interface for the first
time, its EtherNet/IP status indicator is steady green or flashes green
after an initialization.
If it is red or remains off, there is a problem. See Chapter 6
,
Troubleshooting.
ATTENTION: Risk of equipment damage, injury, or death exists. Unpredictable
operation can occur if you fail to Verify that parameter settings are compatible
with your application. Verify that settings are compatible with your application
before power is applied to the drive.
ATTENTION: Wear personal protective equipment (PPE) to avoid death or injury
when applying power with the drive door open.
To Next Page
Loading...
Need help?
General
