Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017 73
Configuring the Drive in a Logix System Chapter 3
Configure a PowerFlex 755T Drive for ADC
ADC is configured within the AOP Device Definition window of the
PowerFlex 755T drives.
1. Open the desired PowerFlex 755T drive in the Logix Designer I/O
Configuration folder and click the Device Definition button.
IMPORTANT ADC may execute the first time the Logix controller connects to the drive
after ADC has been enabled. The configuration signatures in the controller
and drive synchronize, and stops future ADC downloads from occurring
unless a configuration change is made or the drive / peripheral is replaced.
If a port has configuration parameters that require a reset to become active,
ADC will reset the drive after the respective port parameters are
downloaded.
IMPORTANT When ADC is enabled, it can be activated if the controller is in Run or
Program mode. Select ‘Inhibit Module’ when changes are made to the drive
to limit ADC from writing over your changes. ‘Inhibit Module’ is on the
Connection tab in the drive module profile.
IMPORTANT Use select Stratix switches to provide the dynamic IP address assignment by
port. This removes the need to manually enter the IP address, subnet mask,
and Gateway address before connecting a replacement drive to the Ethernet
network.
IMPORTANT ADC can work in tandem with the Firmware Supervisor. If the Firmware
Supervisor is configured and enabled for a drive (‘Exact Match’ keying must
be used), the drive/ peripheral firmware is automatically updated (if
necessary) before any ADC operation for that port.
To Next Page
Loading...
Need help?
General
