Allen-Bradley PowerFlex 755T User Manual

Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017 129
Interface Parameters Appendix C
310
311
312
313
Gateway Cfg 1
Gateway Cfg 2
Gateway Cfg 3
Gateway Cfg 4
Gateway Configuration n
Sets the first, second, third, and fourth byte in the gateway address when parameter 301
[Net Addr Src] is set to 1 ‘Parameters’. If the gateway address is 0.0.0.0, the PowerFlex
755T can only communicate with devices on the same subnet as the drive. It is not able
to communicate with devices on other subnets.
If the gateway address is not set to 0.0.0.0, then it must be set to an address that is on
the same subnet as the drive's IP address.
A power cycle or reset is needed for changes to this parameter to take effect.
Default:
Min/Max:
0
0/255
RW 32-bit
Integer
0
314 Net Rate Cfg 1
Net Rate Configuration 1
Sets the speed and duplex at which the interface communicates on its ENET n network
port.
A power cycle or reset is needed for changes to this parameter to take effect. Updates
0:315 - [Net Rate Act 1]
Default:
Options:
0 = ‘Autodetect’
0 = ‘Autodetect’
1 = ‘10 Mbps Full’
2 = ‘10 Mbps Half’
3 = ‘100 Mbps Full’
4 = ‘100 Mbps Half’
RW 32-bit
Integer
0
315 Net Rate Act 1
Network Rate Actual 1
Displays the active network data rate at which interface n communicates.
Default:
Options:
0 = ‘No Link’
0 = ‘No Link’
1 = ‘10 Mbps Full’
2 = ‘10 Mbps Half’
3 = ‘100 Mbps Full’
4 = ‘100 Mbps Half’
5 = ‘Dup IP Addr’
RO 32-bit
Integer
0
316 Net Rate Cfg 2
Net Rate Configuration 2
Sets the speed and duplex at which the interface communicates on its ENET n network
port.
A power cycle or reset is needed for changes to this parameter to take effect. Updates
0:317 - [Net Rate Act 2]
Default:
Options:
0 = ‘Autodetect’
0 = ‘Autodetect’
1 = ‘10 Mbps Full’
2 = ‘10 Mbps Half’
3 = ‘100 Mbps Full’
4 = ‘100 Mbps Half’
RW 32-bit
Integer
0
317 Net Rate Act 2
Network Rate Actual 2
Displays the active network data rate at which interface n communicates.
Default:
Options:
0 = ‘No Link’
0 = ‘No Link’
1 = ‘10 Mbps Full’
2 = ‘10 Mbps Half’
3 = ‘100 Mbps Full’
4 = ‘100 Mbps Half’
5 = ‘Dup IP Addr’
RO 32-bit
Integer
0
Table 25 - Port 0: Parameter List (continued)
No. Display Name
Extended Name
Description
Values
Read-Write Data Type Parameter 30 [Access Level]

Allen-Bradley PowerFlex 755T Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 755T
Category	Adapter
Language	English