Allen-Bradley PowerFlex 755T User Manual

Rockwell Automation Publication 750COM-UM009A-EN-P - May 2017 25
Chapter 2
Configure the Interface
This chapter provides instructions and information for setting the parameters
to configure the built-in EtherNet/IP interface.
For a list of parameters, see Appendix C
, Parameter List. For definitions of
terms in this chapter, see the Glossary
.
Topic Page
Configuration Tools 26
Setting the IP Address 26
Connecting the Interface to the Network 29
Apply Power 30
Start-up Status Indications 31
Configuring and Verifying Key Drive Parameters 33
Use Interface Parameters to Set the IP Address 33
Using the PowerFlex 20-HIM-A6 or 20-HIM-C6S to Access Parameters 34
Using a BOOTP or DHCP Server 36
Setting the Data Rate 40
Setting Communication Hierarchy 41
Setting a Controller Hierarchy 41
Setting a Fault Action 44
Changing the Fault Action 44
Setting the Fault Configuration Parameters 45
Resetting the Interface 45
Restore Interface Parameters to Default Configurations 45
Viewing the Interface Status Using Parameters 47
Updating the Interface Firmware 47

Allen-Bradley PowerFlex 755T Specifications

General

Brand	Allen-Bradley
Model	PowerFlex 755T
Category	Adapter
Language	English