71
use and maintenance RS 125
CHANGING
THE REAR LIGHT BULB
Carefully read page 69 (BULBS).
Before changing a bulb, check
the fuses, see page 67
(CHANGING THE FUSES) and the
effective operation of the stoplight
switches, see page 68 (CHECKING THE
SWITCHES).
u
Position the vehicle on the stand.
u
HRemove the rider seat, see page 56
(REMOVING THE RIDER SADDLE) .
u
H Remove the panel to gain access to
the tool kit compartment.
u
H Unscrew and remove the two screws
(1).
u
H Remove the passenger seat sliding it
off under the passenger grab strap.
NOTE: Upon reassembly, fit the
passenger seat keys in their housings.
u
Turn the bulb holder (2) anticlockwise
and remove it.
u
Press the bulb (3) slightly and rotate it
anticlockwise.
u
Extract the bulb from its seat.
Insert the bulb in the bulb
socket, making the two bulb pins
coincide with the relevant guides on the
socket.
u
Correctly install a new bulb of the same
type.
u
Refit bulb holder (2) in its housing and
turn it clockwise until it locks in place.
1
2
3
RS_125_UK.book Page 71 Tuesday, June 13, 2006 1:34 PM
To Next Page
Loading...
Need help?
General
