Passwords
Users will be prompted to enter a password any time the unit is
locked and a programming function is accessed. All units are
shipped with the initial pass-
word set to 0 1 0 4.
Once prompted to enter a
password, use the keypad to
enter the four digit code. If
any mistakes are made during
the entry process, the CLR
button can be used to remove
one digit at a time.
As each digit is entered, an asterisk (*) will appear indicating that
a number has been entered. Once all four numbers have been
entered in the proper sequence, the user can press either the
Accept Password soft-key or the ENT button.
If the user wishes to return to the main screen without entering
the password, either the Cancel soft-key or the ESC button may
be pressed.
If the password is entered properly, the user will be taken to the
function that was requested prior to the Enter Password screen
appearing. The password can be changed to any four digit code.
5 RE Qualifier System Manual
To Next Page
Loading...
Need help?
General
