Survivable Branch Appliance
AudioCodes Enhanced Media Gateway 44 Document #: LTRT-18206
3.1.2.1.2 Data-Routing LAN Interface
The default IP address of the LAN data-routing interface is listed in the table below:
Table 3-3: Default LAN Data-Routing IP Address
Parameter Default Value
IP Address
192.168.0.1
Subnet Mask
255.255.255.0
Default Gateway
0.0.0.0
Note: The data-routing interface must be in the same subnet as the VoIP and
Management interface.
¾ To define the device's LAN data-routing IP address:
1. Access the device's Web interface with the IP address that you assigned to the VoIP and
Management interface (refer to “VoIP and Management LAN Interface” on page 43).
2. Access the 'Connections' page (Configuration tab > Data Settings menu > Data System >
Connections).
Figure 3-4: Connections Page
3. Click the "LAN Switch VLAN 1" connection, and then click the Settings tab.
4. In the 'IP Address' and 'Subnet Mask' fields, enter the required IP address (e.g., 10.8.6.85)
and subnet respectively, and then click OK.
Figure 3-5: Defining LAN Data-Routing IP Address
To Next Page
Loading...
Need help?
General
