System Units – Overview
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 17
Power Unit BPS-410
BPS-410: 24V/10A power supply
The unit includes:
Power Board BSF-400, including:
AutroFieldBus interface
115VAC /230VAC input
6 outputs 24VDC (max. 2A each)
1 fault relay output
Dimensions:
HxWxD (mm): 130 x 259 x 120
4.1 Power Supplies
The power cabinet STX Range (three variants) and the BPS-410 Power
Unit are all approved according to EN-54.
In general, the type of power supply must be selected according to
project specifications.
Note:
If BSD-330 (interface between the AutroSafe detector loop protocol and
BS-100 loop protocol) is to be used, the BPS-410 Power Unit must be
used.
Refer to chapter 6.6 and chapter 6.7 for details on mounting.
For further details, refer to datasheets for these power supplies which
you can find on the Autronica product web
http://product.autronicafire.com/products/
To Next Page
Loading...
Need help?
General
