Introduction
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 7
1. Introduction
1.1 About the Handbook
This handbook is intended to provide all necessary information for the
installation of a standard AutroSafe Interactive Fire Detection System,
Release 4. It also gives detailed information on connections to
Autronica’s local area network (AutroNet) and guidelines for the
installation and addressing of loop units.
Information on the connection of detectors and other loop units to the
detection loop is found in a separate handbook.
The chapter «Service and Maintenance» outlines the recommended
monthly and annual service and maintenance procedures that should
be performed after the system has been commissioned.
1.2 Hardware / Software
Systems with SW version 4.10.0 and later can have a mixed
environment consisting of BSA-400A and BSA-400 based panels.
Appendix A provides details on BSA-400A Controller Board in respect
to circuit board layout, components, switches, connectors etc.
For more information about replacement of previous BSA-400
Controller Boards with BSA-400A Controller Boards, refer to separate
handbook.
1.3 The Reader
The handbook is intended to be used by Autronica Fire and Security
trained service and technical personnel who are responsible for the
installation of the AutroSafe Interactive Fire Detection System, Release
4.
All tasks described in the handbook are to be performed without
applying power to the system.
Power must not be applied before commissioning, refer to
Commissioning Handbook.
Note that this handbook deals with the mechanical and electrical
installation only. All tasks described in the handbook are to be
performed without applying power to the system. Power must not
be applied before commissioning, refer to Commissioning
Handbook.
To Next Page
Loading...
Need help?
General
