Mounting Instructions
asafeinstall_dgb, AutroSafe Interactive Fire Detection System, Release 4,
116-P-ASAFE-INSTALL/DGB, Doc-1004796-2, 2021-08-23, Autronica Fire and Security AS
Page 19
6. Mounting Instructions
6.1 Introduction
This following chapters deal with the mounting of:
• Fire Alarm Control Panel BS-420 / Controller BC-420
• Operator Panel BS-430
• Repeater Panel BU-BV-420 (Fire Brigade Panel / Information
Panel)
• Loop Panels (Information Loop Panel BV-110 and Fire Brigade
Loop Panel BU-110)
• Power Cabinet STX Range
• Power Unit BPS-410
The following is delivered together with the system units:
• Fireman’s key (delivered with all system units, except for
BC-420 and BPS-410)
• Unbraco key (to lock/unlock the front panel) – (not delivered
with BPS-410)
• Plastic cap to cover the key hole (Repeater Panel only; when
Repeater Panel BU-BV-420 is to be used as an Information
Panel)
• 11 Rubber glands for entry of external cables
• Text foils
A general description of flush mounting Repeater Panel BU-BV-420 and
Operator Panel BS-430 in a wall is described in a chapter 5.10.
For information on mounting the Controller Rack BC-440, refer to
separate datasheet.
This product contains static-sensitive devices.
Always use an antistatic wrist strap / earth bracelet to avoid any
electrostatic discharge.
To Next Page
Loading...
Need help?
General
