© BEKA 201 !6 All rights reserved
BAL2185_PICO_with_PICOtroniX1_PICOtronic_0816_EN
3. General safety instructions
All persons that are in charge with the assembly, start-up, maintenance and operation of the central lubrication pump
mustcarefully readthese instructions. Furthermorethis operatingmanualalways hasto be availableon site!
Basicnotes forthe setup, operationand maintenance canbe foundbelow!
3.1 Safety instructions:
Please observe the safety instructions within this main point as well as special safety instructions that are included in
otherparts ofthis documentation.
Warningof electricalvoltage
Safety instructions which in case of non-observance might cause hazards to persons are marked with the
generaldanger symbol.
Thissymbol warnsof hot surfaces.
Warningof suspendedloads.
Warning of damage to property due to electrostatic discharge! Marks potential risks which may result in
materialdamage, ifnot avoided.
This heading is used if the improper or general non-observeance of the operating manual,
specifiedwork flowand the like resultin centrallubrication pump damage.might
Thisterm isused to pointout particular details.
Instructions which are directly attached to the central lubrication pump have to be strictly observed and kept in
readable condition!
3.2 Qualification and training of staff
The staff in charge for operation, maintenance, inspection and assembly has to have the according
qualification for these works. Competence, area of authority and staff monitoring must exactly be controlled
by operator. In case the staff does not have the necessary knowledge it has to be instructed and trained.the
Theoperator isobliged that thestafffully understands thecontent ofthisuser information.
Caution!
Note!
To Next Page
Loading...
Need help?
General
