33
Darning
Simple Darning Program No. 22 or Reinforced Darning
Program No. 23
size and type suitable for the fabric selected
lightweight darning thread
up (sewing position)
Automatic buttonhole foot No. 3A
Reverse pattern foot No. 1
Preparation
· stretch fine fabrics into a darning or embroidery ring to
prevent distortion
Simple Darning Program No. 22
·replaces threads along the lengthwise grain in all fabrics
· use with Reverse pattern foot No.1
· touch foot 3 on the toolbar across the lower part of the screen
· sew the first row
·press and release the quick reverse button at the desired
length;this programs the first length
· sew the second row
·press and release the quick reverse button; this programs
the second length
· continue sewing; the machine stops automatically
Reinforced Darning Program No. 23
·replaces threads along the lengthwise and crosswise
grains in all fabrics
· use with Automatic buttonhole foot No. 3A
· insert the needle in the top left of the worn area
· sew the first vertical row
·press and release the quick reverse button at the desired
length;this programs the length needed
· continue sewing; the machine stops automatically when
finished
Large areas
·reposition the work under the foot to continue covering
the worn area
· begin sewing;the program will repeat (length is saved)
Corrections
· if the darning becomes distorted, correct with the Balance
function (see page 44)
Automatic darning
TIPS
Reinforced darning
· place a piece of gauze under the worn area before
darning
Large areas
· increase the darning area lengthwise and crosswise by
moving the work under the foot
Stitch:
Needle:
Thread:
Feed-dog:
Presser foot:
☞
NA_165_englisch 16.4.2004 11:04 Uhr Seite 35
030787.52.04_0401_a165_EN
To Next Page
Loading...
Need help?
General
