CORRECT OPERATION [1]
<Winding the bobbin
thread>
1.
Set power switch 0
to
ON.
2.
Place empty bobbin 8 onto bobbin winder shaft 0
3.
Thread the thread from the spool stand
as
illustrated and wind the thread end around bobbin 8 for
five
to
six turns.
4.
Move lever 8
In
the arrowed direction.
The winder
will start automatically and bobbin winder shaft 0 will revolve
to
wind the thread on the
bobbin.
5.
On completion
of
winding the maximum amount of thread, the lever returns automatically and bobbin
winder shaft
0 will stop revolving.
6.
To adjust the maximum thread amount for bobbin
8,
loosen screw 8 and move lever 8
to
the right
or
left.
7. Remove bobbin 8 from bobbin winder shaft 0 and cut the thread
by
winding It around thread
holder
0.
To wind another bobbin, take the thread
end
from thread holder 0 and wind it around the new one.
-9-
To Next Page
Loading...
Need help?
General
