PROGRAMMING
{Inputting
a
Cycle
Sewing
Program)
• CYCLE
PGM.
allows a maximum of any six combinations from program numbers 1
to
5 .
• See the preceding pages
to
set standard or flap sewing programs for program numbers 1
to
5 .
<Inputting a cycle sewing program>
To set a 1
__.
2-+
1 -+ 3 sewing cycle
1.
Set MODE selector 0 to KNIFE CHANGE &
CYCLE
PGM.
2.
Press
CYCLE
PGM.
CLEAR
switch
8.
3.
Press SELECT selector 0 to Illuminate program number indicator
11
1
11
•
4.
Press
CYCLE
PGM.
-
SET
switch 8 to store program number 1 .
5.
Press SELECT selector 0 to Illuminate program number indicator
11
2
11
•
6.
Press CYCLE
PGM.
-
SET
switch 8
to
store program number 2 .
7.
Press SELECT selector 0 to illuminate program number Indicator
11
1
11
•
8.
Press CYCLE
PGM.
-
SET
switch 8 to store program number 1 .
9.
Press SELECT selector 0 to illuminate program number indicator
11
3
11
•
10.
Press CYCLE
PGM.
-
SET
switch 8
to
store program number 3 .
11.
Move MODE selector
to
any position but KNIFE CHANGE &
CYCLE
PGM.
o If a stacker operation
is
not programmed, it will be automatically programmed after the last program
;-.
number (
11
3
11
above).
o See page 34
to
operate the stacker Independently.
* The modified cycle sewing sequence will be stored when
MODE
selector 0 is moved. The cycle
sewing sequence will remain unmodified if the power switch is set
to
OFF without moving the selector.
*
If
a mistake is made during inputting, press CYCLE
PGM.
CLEAR
SWITCH 8 and Input the program
again from the beginning.
-20-
To Next Page
Need help?
General
