ERROR CODES
• The machine will not operate when characters unrelated
to
the program are shown on the LED displays,
either on turning on the power
or
during sewing:
Please contact
your
Brother dealer if error display cannot be reset.
Contents
of
the codes are as below:
E-1-** Switch-related error
E-2-** Machine-related error
E-4-** Sensor-related error
E-3-** Error related
to
the carriage feed
E-6-** Error related
to
thread breakage
E-8-** Error related
to
the
comer
knife
~
Contents
of
Error Codes
Reset procedure
E-0-00
EMERGENCY
STOP
pressed while carriage feed moving.
See the footnote.
E-1-00
Start
switch pressed when power turned on.
Release start switch.
E-1-01
Treadle pressed for padding cloth presser foot operation
Release start switch.
when power turned on.
E-1-02 Treadle pressed when power turned on.
Release start switch.
E-2-00
Machine motor not stopping at needle
up
position. Turn pulley
to
raise needle.
E-2-01
Needle not at up position at sewing start. Turn power switch off.
E-2-02
Needle not stopping at up position at sewing end. Turn power switch off.
E-3-00
Feed home position overrun (home side). Turn power switch off.
E-3-01
Feed overrun. Turn power switch off.
E-3-02
Feed time-up.
Turn power switch off.
E-3-03
Waiting for a feed command.
Turn power switch off.
E-3-04
Feed error
at
error reset.
Turn power switch off.
E-3-05
Feed fault stop.
Turn power switch off.
E-3-06
Overrun
to
home side when power turned on.
Move
carriage
feed
away
from operator by hand.
E-4-01
Right flap sensor fault.
Same as emergency stop.
E-4-10 Left flap sensor fault.
Same as emergency stop.
E-5-00 Cycle program interrupted.
Cycle program
will be cleared
and
automatically reset.
E-6-01
Right thread breakage.
Same as emergency stop.
E-6-10 Left thread breakage.
Same as emergency stop.
E-7-00 Memory read/write fault.
Replace circuit board.
E-8-01
Corner knife rises at sewing start.
Turn power switch off.
E-8-02 Corner knife locker rod contacting knife bracket when the
Turn power switch off.
rod is caught.
E-8-03
Comer
knife contacting knife bracket while knife operating.
Turn power switch off.
<Emergency
stop>
If the eMERGENCY STOP switch is pressed while the carriage feed is moving, the feed motor and main
motor
will stop immediately. The machine will
now
be in the same status as when the power is first turned
on. The carriage feed
will remain
In
the same position as when the EMERGENCY
STOP
switch was
pressed (see page 33).
-52-
To Next Page
Loading...
Need help?
General
