2. FUNCTION SETTINGS
2-4. List
of
memory switches
No.
Setting
range
Setting items
Default
Work clamp/button clamp
lift timing when sewing is complete
001
OFF
Lifts
at
the final stitch position.
OFF
ON
Lifts after moving to the home position.
2-step work clamp
OFF
Disable
003
Stops
at intermediate work clamp height setting mode when foot switch is OFF
ON
depressed to 1st step, and then drops fully and sewing starts when foot switch is
depressed to 2nd step.
Slow start
OFF
The sewing speed for the first 1 - 5 stitches is set by memory switch nos.
151
-
100
155.
OFF
KE-430D: Slow
start with 1st stitch sewn
at
400 rpm and 2nd stitch sewn at 800
ON
rpm.
BE-438D:
Slow start with 1st and 2nd stitches sewn at 400 rpm.
Sinole-stitch test feed
OFF
Test feed starts when the foot switch
is
depressed, and it continues automatically
200
until
the final stitch.
*1
Test feeding is carried out stitch
by
stitch when the foot switch is depressed.
ON In addition, when the test indicator is illuminated, test feeding will move foiWard
one stitch
at
a time when the machine pulley is turned by hand.
Production counter
display
300
OFF
Lower thread counter display
OFF
ON
Production counter display
User programs
400
OFF
Disable
OFF
ON
User program mode is enabled.
Cycle
programs
401
OFF
Disable
OFF
ON
When sewing user programs, the set programs are sewn in numeric order.
Units display for pattern zoom ratio (*2)
402 .
OFF Displayed as
%.
OFF
ON
Displayed as mm.
Thread nipper device
500
OFF
Disable
OFF
ON
Thread nipper device can be used. {*3)
*1
Off for KE-430D and ON for BE-438D.
*2 The mm display may differ
slightly from the actual sewing size.
*3 May not operate
if
the settings
for
the memory switches have been changed,
or
at some sewing speeds.
*If
memory switch No.
151
and No. 152 are set to a combination that does not appear
in
the following table, the thread
nipper device
will not work.
No.
Setting value [1] Setting value [2}
Setting value [3]
151
15
8
4
152
20 12
6
*
If
the sewing speed is set to a lower speed than the setting for memory switch No. 152, the thread nipper device will not
work.
KE-430D, BE-438D
5
To Next Page
Loading...
Need help?
General
