48
CARE & TROUBLESHOOTING
Refilling the Stamp Ink
If the stamp is faint or incomplete, use the ink bottle (sold separately) to refill the ink.
1 Remove the holder from the stamp.
2 Use the ink bottle to add five drops of ink to each refill hole in the
stamp.
☞ NOTE: Be extremely careful when adding ink.
Do not use ink other than that specified,
otherwise the stamp may be damaged.
If too much ink is added, it may start leaking
from the stamp’s surface. In that case, make
a test stamp on scrap paper to remove any
excess ink.
3 Put the holder back on the stamp.
☞ NOTE: Immediately after refilling the ink, keep the
stamp facing down until the ink begins to
flow from the stamp.
After refilling the ink, be sure to put the cap
back on the refill ink bottle.
Ink bottle
Refill holes
Holder
To Next Page
Loading...
Need help?
General