DESIGINING A STAMP
51
CARE & TROUBLESHOOTING
SOLUTION
• Close the ink ribbon compartment cover.
• Install the ink ribbon cassette.
• Replace the ink ribbon cassette.
• Install the xenon lamp unit.
• Replace the xenon lamp unit.
• Insert an ID label sheet into the ID label slot.
•
Correctly insert the specified draft sheet or ID label sheet into the ID label slot.
• Remove the draft sheet or ID label sheet from the ID label slot, or pull out
the draft sheet magazine tray and remove the draft sheet.
• Open the ink ribbon compartment cover, and then remove the draft sheet
or ID label sheet.
• Open the ink ribbon compartment cover, remove the xenon lamp unit, and
then remove the draft sheet or ID label sheet.
• Insert a stamp that is the correct size.
• Re-insert the stamp.
• Check the interface cable connections.
• For Serial connection only, check the COM port settings on the PC.
Bits per second : 115200
Data bits : 8
Parity : None
Stop bits : 1
Flow Control : Hardware
• Contact your service representative.
• Check the interface cable connections.
• Contact your service representative.
• Contact your service representative.
• Contact your service representative.
• Replace the xenon lamp unit.
• Contact your service representative.
• Contact your service representative.
• Load draft sheets into the draft sheet magazine tray, and then insert the
draft sheet magazine tray into the draft sheet magazine tray slot.
• Clean the draft sheet rollers using a cleaning sheet.
• Contact your service representative.
• Turn off the machine, and wait for one minute before turning on the ma-
chine and trying to print again.
MESSAGE
CLOSE COVER !
CHECK RIBBON !
INSTALL Xe UNIT
REPLACE Xe UNIT
INSERT LABEL !
CHANGE LABEL !
REMOVE LABEL 1
REMOVE LABEL 2
REMOVE LABEL 3
CHANGE STAMP !
RESET STAMP !
I/F ERROR !
CACHE FULL !
SRAM DEFECT !
HEAD ERROR !
Xe UNIT ERROR !
SIZE PCB ERROR!
CHECK TRAY !
CHARGE ERROR !
Error message list
To Next Page
Loading...
Need help?
General