REMOTE CONTROL
Equipped as standard is the 005 remote control
Switching on/off The POWER button switches the preamp on or off, provided the Mains switch of the
external power supply unit or on the rear panel of the preamp is set to ON and the power
switch on the front panel of the preamp is set to STBY.
Input selection The buttons TUNER, PHONO, TAPE, DISC, AUX, SURR activate the according input. If
you have renamed the inputs the buttons will react as follows:
• TUNER: all inputs with the character combinations TU, DAB, DVB, ADR, RADIO, RDS,
053, 993, 931, 915, 978 in its name
• PHONO: all inputs with the character combinations PH, VINYL, PLATTE, in its name
• TAPE: all inputs with the character combinations TAPE, DAT, REV, BAND in its name
• DISC: all inputs with the character combinations CD, DVD, DISC, BD, MD, LD, VD,
001, 006, 052, 061, 069, 088, 992, 937, 916, 917, 963, 939 in its name
• AUX: all inputs with character combinations which are not listed above will be toggled
through
• SURR: the INPUT 6/SURR can only be operated if you select SURROND in the
SETUP menu for INPUT 6
NOTICE: If you have multiple inputs with same characters (for example CD1 and CD2), you
will be able to toggle through those inputs with the DISC button on your remote control.
Furthermore you have the option to switch through all inputs, independent of the names,
with the buttons STATION+ and STATION-. With the STATION+ button in ascending order
(INPUT 1 INPUT 2 etc…), with the STATION - button in descending order (INPUT 4
INPUT 3 etc…).
NOTICE: To be able to use the STATION keys you have to activate the option in the
GLOBAL SETUP / RC INPUT.
Playback volume With the buttons VOLUME + and VOLUME - you are able to adjust the volume for the
selected MAIN or RECORD level. The volume level is shown in the display. By shortly
pressing the VOLUME buttons you are able to change the volume in small steps.
To be able to use the volume buttons on the RECORD level you have to choose the
function VARIABLE VOLUME in the RECORD MENU.
Display brightness With the DIM button you are able to adjust the brightness of the display in 4 steps. These
steps vary between “max. brightness” and “off”.
If you choose the option “off” the display will only light up when you change anything. This
gives you a feedback about the changes you are applying. When you are done with your
changes, the display will go blank again after a couple of seconds. If you enter the SETUP
MENU while display is “off”, it will automatically go to “maximum brightness” for the time you
are in the SETUP MENU.
To Next Page
Loading...
Need help?
General
