BURLINK
CONNECTIONS
Connections to the BURLINK interface can either be done by the 9-pin D-SUB connector (RS-232) or by the USB
connector.
RS-232 configuration: 9600Baud, 8bit, parity: none, 1 stop bit, no hardware handshake
A USB device driver needs to be installed when using the USB connector. System requirements for using the USB
software are either WINDOWS 2000 or WINDOWS XP operating system.
COMMANDS
Listed below are the possible commands to control the preamp 077. All commands needs to be sent in capital letters
finished with a “carriage return“ \r .
POWON\r switches the unit on
POWOFF\r switches the unit to standby mode
INP+\r switches the inputs of the preamp
INP-\r switches the inputs of the preamp
INP1\r switches to input 1
INP2\r switches to input 2
INP3\r switches to input 3
INP4\r switches to input 4
INP5\r switches to input 5
INP6\r switches to input 6
INP_MOD\r switches to module input
DAC_SRC_INP\r switches between the inputs of the D/A converter module, if equipped
DAC_SRC_RCA\r switches to the RCA input of the D/A converter module, if equipped
DAC_SRC_USB\r switches to the USB input of the D/A converter module, if equipped
VOLUP\r increases the volume by one step
VOLDN\r decreases the volume by one step
VOL_BURxx\r sets the volume level to the value xx referred to the BURMESTER scale
VOL_DByxx\r sets the volume level to the value xx referred to the dB scale
(y=algebraic sign + or -, respectively a blank space with the value 00)
MR_COND\r switches between MAIN and RECORD level
MAIN_COND\r switches to MAIN level
REC_COND\r switches to RECORD level
To Next Page
Loading...
Need help?
General
