CAME GARD series Installation Manual

%##
,
.
28
48 '.$
28
48 '.$
,
.
%##
SX
DX
%







#
#
'.$4828
.
-
04 & &#
&!
.
,
,
,4
/.

 
'.$48
28
%







#
#
.
-
04 & &#
&!
.
,
,
,4
/.

 
p.
23
23 - Manual Code:
119 G V18
119GV18ver.
1.1
1.1 12/2011 © CAME Cancelli Automatici S.p.a. - The data and information in this manual may be changed at any time and without obligation on the part of Came Cancelli Automatici S.p.a. to notify said changes.
ENGLISH
7 ON
You must decide which is the Master barrier and which is the Slave
barrier, because:
- whereas, on the
Slave barrier, just
connect the power
source (terminals L-N)
and pertinent signal
and warning devices
(terminals 10-E);also,
set Dip switch 7 to ON,
adjust the travel and
deceleration speeds as
on the Master barrier.
- on the Masterbarrier
perform all connec-
tions, settings and
adjustments needed
on the installa-
tion;also activate the
remote control.
ELECTRONIC CARD MASTER
ELECTRONIC CARD
SLAVE
At the end, connect the two cards together using the terminalsRX-TX-GND.
Black
Red
Black
Red
Screened cable
2402C 22AWG
ELECTRONIC CARD
MASTER
ELECTRONIC CARD
SLAVE
Connecting two coupled barriers

CAME GARD series Specifications

General

Brand	CAME
Model	GARD series
Category	Control Systems
Language	English