39
Focusing Point Selection
Automatic Selection
Manual Selection
Press the < > button and turn
the < > dial.
Turn the dial until the viewfinder
display is as shown on the left. You
can also turn the < > dial.
• While in the manual selection mode,
shifting the focusing point beyond the
peripheral focusing point will set the
automatic selection mode.
The automatic selection mode can also
be set while C.Fn-13-1/2/3 has been set.
• Select the focusing point as
described in “Basic Procedure for
Focusing Point Selection.”
• When a vertical focusing point is
selected, the selection will alternate
between one ( ) and double
focusing points (
(1) Manual selection of 45 focusing points
If double focusing points are selected, focusing point selection will be automatic
with both focusing points. If you then select the left or right focusing point, only
that focusing point will be active.
Center focusing point selected.
Off-center focusing point selected.
Double focusing points selected.
SEC.03 P033-048 (E) 28-01-2003 16:04 Pagina 39
To Next Page
Loading...
Need help?
General
