Canon imageCLASS MF3010 - Installation and Handling; Temperature and Humidity Conditions; Power Supply Requirements

Installation and Handling
85RS-008
T
o make sure safe and trouble-free operation, the following installation requirements must be observed.
Read the instructions carefully before installing the machine.
T
emperature and Humidity Conditions(P. 15)
Po
wer Supply Requirements(P. 15)
Installation Requir
ements(P. 16)
Installation Space
(P. 17)
Maintenance and Inspections
(P. 17)
Customer Support
(P. 17)
IMPORTANT
Important Safety Instructions
Be sur
e to read "Important Safety Instructions" before installing the machine.
Temperature and Humidity Conditions
● T
emperature range: 10 to 30°C (50 to 86°F)
● Humidity range: 20 to 80 % RH (no condensation)
IMPORTANT
Protecting the machine from condensation
● Allo
w the machine to adjust to the installation environment (room temperature and humidity) for at
least two hours before using, to prevent condensation from forming inside the machine when:
- the installation location is warmed up too rapidly.
- the machine has been moved to a hot, humid location from a cool, dry location.
● If water dr
oplets (condensation) form inside the machine, this may result in paper jams or poor print
quality.
To use an ultrasonic humidier
W
e recommend that puried or impurity-free water be used when using an ultrasonic humidier.
The use of tap water or well water may result in contamination by impurities in the air, as well as print
quality degradation due to water trapped inside the machine.
Power Supply Requirements
110 to 127 V
, 50/60 Hz
IMPORTANT
Precautions when connecting the power cord
● Do not connect the machine to an uninterruptible power source.
Important Safety Instructions
15