1
1
1-6
1-6
Initial Setup > Basic Operation > Warning List Screen in Operator Maintenance Mode > Control keys
Initial Setup > Basic Operation > Warning List Screen in Operator Maintenance Mode > Control keys
Warning List Screen in Operator Maintenance Mode
When moving to Operator Maintenance mode, the warning list is shown on operator
maintenance basic screen. To switch from the other screen display, press [Warning] and the
warning list is displayed.
The parts in the warning status are listed here. The parts in the warnings status mean
replacement/cleaning parts in shorter service life. The parts are listed in the descending order
from higher to lower rates in the wear status.
CAUTION:
This is the screen when logging in the Operator Maintenance mode, so any changes
made during login are not reected here.
F-1-10
■
Display
Items Contents
Item No. 8 digits characters and/or numbers (format XXX-XXXX)
Replacement/
Cleaning Icons
Replacement icon
Cleaning icon
Maintenance Max. 54 single byte characters (overow will be rounded)
Wear Status 0 to 999 %
Count 8 digit numbers
Recommended Value 8 digit numbers
NOTE:
In the warning list, the parts in 100% or more of the wear status rate are shown in the
default setting. This setting can be changed to show the parts in 90% or more of the
wear status rate. Contact your service representative to change this setting.
■
Control keys
Names of Key Function
Details Select a parts to enable [Details] key.
Press this key to display the detailed information screen.
"Detailed Information Screen"(page 1-10).
Counter Operation Select a parts to enable [Counter Operation] key.
Press this key to clear the counter.
"Clearing the Counter"(page 1-12).
T-1-3
T-1-4
To Next Page
Loading...
Need help?
General