Canon imagePRESS C800 Series Operator's Maintenance Manual

1
1
1-16
1-16
Initial Setup > Basic Operation > Replacement/Cleaning Mode > Terminating Replacement/Cleaning Mode
Initial Setup > Basic Operation > Replacement/Cleaning Mode > Terminating Replacement/Cleaning Mode
■
Terminating Replacement/Cleaning Mode
After the replacement or cleaning of the target parts is nished, clear the counters, exit
Replacement/Cleaning mode, and then return to Operator Maintenance mode.
(For clear the counter, refer to "Clearing the Counter"(page 1-12).)
1) Press [End Rplcmt./Cleaning] on replacement/cleaning mode screen in Operator
Maintenance mode.
-> The message will be shown on the screen to conrm Replacement/Cleaning mode
termination.
2) Press [Yes].
F-1-32
F-1-33
-> Close Replacement/Cleaning mode to return to Operator Maintenance mode. Then
the operator maintenance basic screen is shown.

Canon imagePRESS C800 Series Specifications

General

Brand	Canon
Model	imagePRESS C800 Series
Category	Printer
Language	English