1
1
1-14
1-14
Initial Setup > Basic Operation > Clearing the Counter > Procedure for Clearing the Counter of the Secondary Transfer Outer Roller / Fixing Refresh Roller
Initial Setup > Basic Operation > Clearing the Counter > Procedure for Clearing the Counter of the Secondary Transfer Outer Roller / Fixing Refresh Roller
■
Procedure for Clearing the Counter of the Secondary Transfer
Outer Roller / Fixing Refresh Roller
NOTE:
• When clearing the counter of the Secondary Transfer Outer Roller, perform 1-1.
• When clearing the counter of the Fixing Refresh Roller, perform 1-2.
1-1) In the Warning or Replaceable Parts screen, select [Secondary Transfer Outer Roller],
and press [Counter Operation].
1-2) In the Warning or Cleanable Parts screen, select [Fixing Refresh Roller], and press
[Counter Operation].
F-1-24
F-1-25
-> The conrmation screen for clearing the counter will appear.
2) Press [Yes].
-> The count clear completion screen will appear.
Count clear can be executed whether in the Replacement/Cleaning mode or not. If executing
count clear in the Replacement/Cleaning mode, the message will be shown on the screen to
conrm Replacement/Cleaning mode termination after clear.
F-1-26
F-1-27
F-1-28
To Next Page
Loading...
Need help?
General