Cause Corrective Action
When borderless printing is used, the edge
of the paper is cut during printing. Thus, ink
density may be slightly uneven at the lead-
ing edges.
Specify No in Auto Cut in the printer driver before printing. In this case, the paper can be prin-
ted without borders on the left and right sides only. Cut the printed document ejected from the
printer, and then use scissors or a cutting tool to cut away the edges on the top and bottom.
Choose a higher level of Print Quality in the Advanced Settings of the printer driver.
(See "Giving Priority to Particular Graphic Elements and Colors for Printing.") →P.63
The Printhead is out of alignment. Adjust the Printhead alignment.
(See "Automatic Adjustment to Straighten Lines and Colors (Head Posi. Adj.).") →P.604
Allowing printed documents to dry on top of
each other may cause uneven colors.
To avoid uneven colors, we recommend drying each sheet separately.
Density may be uneven if you use Glossy
Paper or Coated Paper.
In Advanced Settings of the printer driver, choose Highest or High in Print Quality.
The type of paper specified in the printer
driver does not match the type loaded in the
printer.
Load paper of the same type as you have specified in the printer driver.
(See "Loading Rolls in the Printer.") →P.446
(See "Loading Sheets in the Printer.") →P.465
Make sure the same type of paper is specified in the printer driver as you have loaded in the
printer.
1.
Press the Stop button and stop printing.
2.
Change the type of paper in the printer driver and try printing again.
Scan Wait Time > Area in the Control Panel
menu is set to Leading edge.
When Scan Wait Time > Area is set to Leading edge, colors may be uneven 110–140 mm
from the leading edge. (The position varies depending on the Print Quality setting.)
In this case, select Scan Wait Time > Area > Entire area.
However, note that printing will now take longer.
(See "Menu Settings.") →P.500
Image edges are blurred or white banding occurs
Image edges are blurred or white banding occurs
Cause Corrective Action
The Platen suction is too strong. In the Control Panel menu, set VacuumStrngth to Weakest.
(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.617
The Printhead is set too high in the Control
Panel menu.
In the Control Panel menu, set Head Height to Lowest.
(See "Troubleshooting Paper Abrasion and Blurry Images (Head Height).") →P.610
The type of paper specified in the printer driv-
er does not match the type loaded in the print-
er.
Load paper of the same type as you have specified in the printer driver.
(See "Loading Rolls in the Printer.") →P.446
(See "Loading Sheets in the Printer.") →P.465
Make sure the same type of paper is specified in the printer driver as you have loaded in the
printer.
1.
Press the Stop button and stop printing.
2.
Change the type of paper in the printer driver and try printing again.
The contrast becomes uneven during printing
The contrast becomes uneven during printing
Cause Corrective Action
The paper feed amount is out of adjustment. Adjust the feed amount.
(See "Adjusting the Feed Amount.") →P.611
The type of paper specified in the printer driver
does not match the type loaded in the printer.
Load paper of the same type as you have specified in the printer driver.
(See "Loading Rolls in the Printer.") →P.446
(See "Loading Sheets in the Printer.") →P.465
Make sure the same type of paper is specified in the printer driver as you have loaded in
the printer.
1.
Press the Stop button and stop printing.
iPF765
Image edges are blurred or white banding occurs
User's Guide
Troubleshooting Problems with the printing quality
669
To Next Page
Loading...
Need help?
General
Weight and Dimensions
