"Remove paper and check pap. size"
Cause Corrective Action
A sheet has come out of the printer during printing.
1.
Press the Release Lever back and remove the paper.
2.
Reload the sheet, aligning it with the guide on the right.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is shown on the Display
Screen, press the OK button.
Printing will resume, starting from the page on which the error occurred.
(See "Loading Sheets in the Printer.") →P.465
PaprWidth Mismatch
PaprWidth Mismatch
Cause Corrective Action
When Detect Mismatch in the Control Panel menu is set to
Pause or Warning, the width of the loaded roll does not
match the width specified in Fit Roll Paper Width in the print-
er driver.
Press ▲ or ▼ to select Print, and then press the OK button to resume print-
ing.
However, note that this error may cause paper jams and affect the printing
quality.
Press ▲ or ▼ to select Stop Printing, and then press the OK button.
Follow these steps to replace the roll to match the width specified in the printer
driver.
1.
Press ▲ or ▼ to select Change Paper, and then press the OK button.
(See "Removing the Roll from the Printer.") →P.451
(See "Removing the Roll Holder from Rolls.") →P.454
2.
Replace the paper with paper compatible for borderless printing.
(See "Attaching the Roll Holder to Rolls.") →P.443
(See "Loading Rolls in the Printer.") →P.446
The printer now starts printing the print job.
Make sure the roll width selected in the dialog box displayed when you select
Fit Roll Paper Width in the printer driver matches the width of the roll loaded
in the printer, and then try printing again.
Paper size not detected.
Paper size not detected.
Cause Corrective Action
Paper has been loaded askew, or warped paper has been loaded. Follow these steps to reload the roll.
1.
Push the Release Lever back.
2.
Adjust the right edge of the roll to make it parallel to the orange Pa-
per Alignment Line.
3.
Pull the Release Lever forward.
4.
If "Not finished printing. Finish printing remaining jobs?" is
shown on the Display Screen, press the OK button.
Printing will resume, starting from the page on which the error oc-
curred.
(See "Loading Rolls in the Printer.") →P.446
If this error recurs after you reload the roll, remove the Roll Holder from
the printer, push the roll firmly in until it touches the Roll Holder flange,
and reload the Roll Holder in the printer.
(See "Attaching the Roll Holder to Rolls.") →P.443
Follow these step to reload a sheet.
PaprWidth Mismatch
iPF765
User's Guide
Error Message Messages regarding paper
688
To Next Page
Loading...
Need help?
General
Weight and Dimensions
