Routine Cleaning
If the original is not copied clearly, clean the following parts of the machine. For high-quality printouts,
we recommend cleaning these parts once or twice a month.
Platen glass
Underside of the feeder
Feeder scanning area and rollers
When cleaning the machine, rst turn OFF the main power switch, and disconnect the power cord. •
Failure to observe these steps may result in a re or electrical shock.
Disconnect the power cord from the power outlet regularly, and clean the area around the base of the •
power plug's metal pins and the power outlet with a dry cloth to ensure that all dust and grime is
removed. If the power cord is connected for a long period of time in a damp, dusty, or smoky location,
dust can build up around the power plug and become damp. This may cause a short circuit and result in
a re.
When cleaning with a cloth, do not dampen it too much, as this may damage the original or break the •
machine.
Do not use alcohol, benzene, paint thinner, or other solvents for cleaning. Doing so may result in damage to •
the plastic parts.
Cleaning the Platen Glass and
Underside of the Feeder
If the platen glass or the underside of the feeder is
dirty, the original may not be scanned clearly. Clean the
platen glass and the underside of the feeder by
following the procedure below.
Clean the platen glass and the 01
underside of the feeder with a cloth
which is wrung after being dampened
in water or a mild detergent, and then
wipe them clean with a soft, dry cloth.
1. Clean the platen glass.
Also, clean the feeder scanning area (thin glass
strip).
2. Clean the underside of the feeder.
Manual Feeder Cleaning
If originals that have been fed through the feeder have
streaks or appear dirty, clean the feeder's rollers.
It is recommended that you clean the rollers of the
feeder with a cloth which is wrung after being
dampened in water, and then wipe them clean with a
soft, dry cloth.
Spin the rollers while cleaning them.•
If the document feed scanning area is dirty, •
documents may not be scanned clearly.
Do not dampen the cloth too much, as excess •
water may damage the machine.
Gently open the 01 feeder cover.
*: Feeder Cover
To Next Page
Loading...
Need help?
General
