unit's telephone number, time, and date as described
in Basic Operations or Settings/Registration in the
e-Manual.
Users in Canada
Preinstallation Requirements for Canon Facsimile
Equipment
The fax function is available only if the FAX Board is
installed.
A. Location
Supply a suitable table, cabinet, or desk for the
machine. See "Specications" in this guide for specic
dimensions and weight.
B. Order Information
1. A single telephone line (touch-tone or rotary)
should be used. If the Super G3 2nd Line Fax Board
is installed, a multi telephone line (touch-tone or
rotary) can be used.
2. Order a CA11A modular jack which should be
installed by the telephone company. If the CA11A
jack is not present, installation cannot occur.
3. Order a normal business line from your telephone
company's business representative. The line should
be a regular voice grade line or an equivalent one.
Use one line per unit. If the Super G3 2nd Line Fax
Board is installed, you can use a multi-line.
DDD (Direct Distance Dial) line
or
IDDD (International Direct Distance Dial) line if you
communicate overseas
Canon recommends an individual line following
industry standards, i.e., 2500 (touch-tone) or 500
(rotary/pulse dial) telephones. A dedicated extension
off a PBX (Private Branch eXchange) unit without "Call
Waiting" can be used with your facsimile unit. Key
telephone systems are not recommended because
they send nonstandard signals to individual
telephones for ringing and special codes, which may
cause a facsimile error.
C. Power Requirements
The power outlet should be a three-prong grounded
receptacle (Single or Duplex). It should be independent
from copiers, heaters, air conditioners, or any electric
equipment that is thermostatically controlled. The
rated value is 115 volts and 15 amperes. The CA11A
modular jack should be relatively close to the power
outlet to facilitate installation.
Notice
This product meets the applicable Industry Canada •
technical specications.
Before installing this equipment, users should •
ensure that it is permissible to be connected to the
facilities of the local telecommunications company.
The equipment must also be installed using an
acceptable method of connection. In some cases,
the company's inside wiring associated with a
single line individual service may be extended by
means of a certied connector assembly (telephone
extension cord). The customer should be aware
that compliance with the above conditions may not
prevent deterioration of service in some situations.
The Ringer Equivalence Number is an indication •
of the maximum number of devices allowed to be
connected to a telephone interface. The termination
of an interface may consist of any combination of
devices subject only to the requirement that the sum
of the RENs of all the devices does not exceed ve.
The REN of this product is 1.0.•
Repairs to certied equipment should be made •
by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations
made by the user to this equipment, or equipment
malfunctions, may give the telecommunications
company cause to request the user to disconnect the
equipment.
Users should ensure for their own protection that •
the electrical ground connections of the power
utility, telephone lines, and internal metallic water
pipe system, if present, are connected together. This
precaution may be particularly important in rural
areas.
Users should not attempt to make such
connections themselves, but should contact the
appropriate electric inspection authority, or
electrician, as appropriate.
This equipment complies with the Canadian ICES-003
Class A limits.
Utilisation au Canada
Conditions à Remplir Préalablement à L'installation
d'un Télécopieur Canon
La fonction de Fax est disponible uniquement
lorsqu'une carte FAX est installee.
A. Emplacement
Prévoir une table, un meuble, ou un bureau
susamment solide et de taille appropriée (voir
"Spécications" pour les indications de poids et
To Next Page
Loading...
Need help?
General
