When an Error Message/Error Code Is Displayed 59
Do not connect or disconnect the power cord
with wet hands, as this may result in electrical
shock.
Always grasp the power plug when
disconnecting the power cord. Pulling on the
power cord may expose or snap the core wire, or
otherwise damage the power cord. If the power
cord is damaged, this could cause current to
leak, resulting in a re or electrical shock.
When you contact your local authorized Canon dealer,
have the following information available:
Product name•
Details of the malfunction•
The error code displayed on the touch panel display•
Setting the Limited Functions
Mode from the Service Call
Message Screen
When [Limited Func. Mode] is displayed, follow the
procedures below.
If you turn OFF the main power switch when there is
a job waiting to print, that job is erased.
If you set Limited Functions Mode to 'On' from the
Service Call Message screen, [Limited Functions Mode]
in [Management Settings] (Settings/Registration) is
also set to 'On'. (See e-Manual > Security.)
Press [Limited Func. Mode] 01 [Yes].
A message prompting you to restart the
machine (turning the main power switch OFF,
and then ON) appears.
Press the main power switch to the 02
" " side.
Wait at least 10 seconds after the Main 03
Power Indicator is turned o, and then
turn the main power switch back to "I"
side.
The machine starts up in the Limited Functions
mode.
To Next Page
Loading...
Need help?
General
