Introduction 20
• Do not block the vents. Blocking the vents can cause your projector to
overheat and may cause a malfunction.
• Do not brush or rub the top surface of the projector The surface may be
damaged.
Control panel and indicators
Air intake
Air
intake
Air
intake
Air exhaust
Air exhaust
Air exhaust
Air
exhaust
Speaker
Speaker
Air intake vent
in the base
2. POWER button/POWER LED
indicator
Lights up or flashes when the
projector is operating. Turns the
projector on or off.
3. INPUT button
Toggles through the input signals in
order.
(P28)
Press and hold for 3 seconds to
enable or disable the key lock. (P74)
1. STATUS LED indicator
The LEDs indicate the projector's
status.
(P88)
1
2
3
To Next Page
Loading...
Need help?
General
