29 Projecting
The default aspect ratio for the projector is 16:10.
Depending on the input signal, the aspect ratio
may not be displayed correctly. If this occurs, you
need to change the aspect ratio. See "Aspect" on
page 79 for details.
When PC/Component, HDMI, or VIDEO is
selected, the last used input signal is
automatically selected the next time the projector
starts up.
Adjusting volume
Follow the steps below to adjust the volume of the projector's internal speaker or the
volume being output from the audio output jack.
Audio volume
Press the VOL-/VOL+ buttons on the remote control to
adjust the volume.
Muting
Press the MUTE button on the remote control to
temporarily mute the audio.
Press the MUTE button again to restore the audio.
Audio is not output when no input signal is being
projected. However, when playing an audio file, audio can be output even when no
image is being projected. In this situation, you can adjust the volume.
* If no audio is output for the image being projected, check that the audio input is
connected to the projector correctly.
* When an external speaker is connected, audio is not output from the internal
speaker.
MUTE VOL- VOL+
PC HDMI VIDEO
AUTO
PC
MENU BACK
MUTE VOL- VOL+
PC HDMI VIDEO
MENU BACK
MUTE VOL- VOL+
PC HDMI VIDEO
To Next Page
Loading...
Need help?
General
