33 Projecting
Adjusting the image height
The projector is equipped with 2 adjuster feet. Use
the front adjuster foot to adjust the height, and the
rear adjuster foot to adjust the inclination of the
image.
If the projector is not placed on a horizontal
surface or the screen and the projector are not perpendicular to each other, the
projected image becomes trapezoidal. To correct this distortion, see "Keystone" on
page 82 for details.
• Do not look into the lens while the light source is on. Strong light from the light
source may damage your eyes. Be especially careful that children do not stare
directly into the lens.
• Be careful when adjusting the feet as they are close to the exhausts that vent
hot air. The cabinet etc. gets very hot which could cause a burn.
• The adjuster feet can be a choking hazard if swallowed accidentally by small
children. Make sure these are placed out of the reach of children. If they are
swallowed accidentally, contact a physician immediately.
When attaching a camera tripod
• When adjusting the height using a tripod, be careful that the projector does
not fall. If it falls a malfunction could occur.
• See the documentation provided with the tripod for more information on
handling and operating the tripod.
• When using an elevating tripod, do not extend the elevator. This could cause
the projector to fall.
To Next Page
Loading...
Need help?
General
