111
Menu Description
Advanced Guide Menu Description
HDBaseT
Enable or disable HDBaseT. Refer to the following sections for details on HDBaseT
connections. For video/audio details, see “Connection Procedure” (P50, P51). For network
details, see “Connection Methods” (P120).
Option Function
Off Disable HDBaseT.
On Enable HDBaseT.
Image signal
quality
The HDBaseT input signal value received is indicated by a white line.
High
Indicated by the green portion. This is the recommended
level.
Middle
Indicated by the yellow portion. The signal is fluctuating.
Check the cable.
Low
Indicated by the red portion. The signal cannot be used. Fix
the cable connection or replace the cable.
Communication settings
Select ports used for serial communication and network connections. Otherwise, you can
refer to this setting to check setting values for the port selected for serial communication.
Submenu Function
Serial
communication
Service port Use the service port (CONTROL).
HDBaseT Use the HDBaseT port.
Details
Wired network
LAN port Use the LAN port.
HDBaseT Use the HDBaseT port.
Do not coil or bundle cables.
Option Function
Stop bit Length of mark representing the end of data bits.
Baud rate Modulation rate, in bits per second.
Data bits Number of bits of data.
Parity Number of parity bits.
• [HDBaseT] is not available when [HDBaseT] (P111) is set to [Off].
• [Wired network] is not available when [Network function] (P124) is set to [Off].
• Changes to the wired network setting do not take effect immediately. To apply [Wired
network] settings, restart the projector.
To Next Page
Loading...
Need help?
General
