EasyManuals Logo
Home>Canon>Projector>WUX6010

Canon WUX6010 User Manual

Canon WUX6010
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #191 background imageLoading...
Page #191 background image
191
Troubleshooting
Other Information Troubleshooting
Symptoms and Solutions
You Cannot Turn on the Projector
WARNING
(only) flashes 3
times
repeatedly.
Filter error The air filter is not installed. Check whether or not
the air filter is installed correctly. Contact the
Canon Customer Support Center if the same
warning occurs again.
WARNING
(only) flashes 6
times
repeatedly.
Faulty lens
connector
The lens cable is not connected to the lens unit
correctly. Unplug the projector, connect the lens
cable to the lens unit correctly, and then plug the
projector in again. Contact the Canon Customer
Support Center if the same warning occurs
again.
Cause Countermeasure
The power cord is not
connected correctly.
Check whether the power cord is connected
correctly. (P52)
The power cord has just
been connected.
Wait at least one second after plugging the projector
in until you press the POWER button. You cannot
turn the projector on immediately after plugging it in.
(P53)
The lamp cover is open. Unplug the projector from the power outlet, then
install the lamp cover correctly and turn on the
projector again.
The safety device is
activated because the air
intake or the exhaust
vent is blocked and the
internal temperature of
the projector has
increased.
When the safety device is active, the [POWER ON]
indicator does not turn on when you connect the
power cord. You cannot disable this safety device.
Remove any obstacle that is blocking the air intake or
exhaust vent and contact the Canon Customer
Support Center.
The lens connector is
not attached correctly.
The lens cable is not connected to the lens unit
correctly. Unplug the projector, connect the lens
cable to the lens unit correctly, and then plug the
projector in again. Contact the Canon Customer
Support Center if the same warning occurs again.
The air filter is not
installed correctly.
Check whether the air filter is installed correctly.
(P164)
Key lock is enabled.
Check that Key lock (P109) is not enabled for the
projector or the remote control.
LED indicator
status
Meaning Cause and countermeasure

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Canon WUX6010 and is the answer not in the manual?

Canon WUX6010 Specifications

General IconGeneral
BrandCanon
ModelWUX6010
CategoryProjector
LanguageEnglish

Related product manuals