Menu Description
124
Network standby settings
> [Network settings] > [Network standby settings]
Specify the network function operating status in standby mode as follows.
Network function
> [Network settings] > [Network function]
Enable or disable network function.
Specifying [Off] can save energy.
Option Function
Normal
All network functions are available even in standby mode,
including the web screen, control over the network, and PJLink.
Low-power
All network functions are available even in standby mode.
However, the projector may be less responsive than usual when
some functions are initially used.
• [Low-power] may delay access over the network for some functions. For faster access,
select [Normal].
• Power consumption when Network function is [On] varies depending on whether
Network standby settings is set to Normal or Low-power.
• This setting can also be adjusted from the power saver settings screen by pressing the
LAMP button on the remote control.
Option Function
Off Disable the network function.
On Enable the network function.
To Next Page
Loading...
Need help?
General
