Menu Description
146
Controlling the Projector from a Computer
When the projector is connected to a network, it is possible to control the projector
from a computer via the network.
1 Turn on the computer and projector.
2 Launch a web browser, enter “http://(projector IP address)” in the
address bar, and press the Enter key.
The projector web screen appears.
3 Click [Projector control] on the web screen.
The password input window appears.
4 Enter the user name and password on the password input window, then
click [OK].
The factory default user name is “root” and the password is “system”.
The projector control screen appears.
The projector can be controlled from this screen.
The factory default IP address is “192.168.254.254”. If DHCP settings are used, ask the
network administrator for the projector IP address. It is possible to check the IP address
from the projector menu.
Item Explanation
Projector name The name of the connected projector is displayed. (P141)
Comment Shows notes, such as where the projector is installed. (P141)
Refresh Refreshes the displayed contents with the most recent information.
Power Turns projector power on or off.
Input Select an input signal and click [Apply] to change to that input signal.
(P56)
Aspect Select an aspect and click [Apply] to change to that aspect. (P65)
Image mode Select an image mode and click [Apply] to change to that image mode.
(P70)
Blank Switches the blank setting on or off. (P72)
Mute Switches the mute setting on or off. (P35)
Auto PC Click [Apply] to perform Auto PC adjustment. (P58)
To Next Page
Loading...
Need help?
General
