Before Installation
22
■ Install Facing in the Correct Direction
When installing the projector facing upward or downward, specify which way the projector
is facing in [Install settings] > [Professional settings] > [Vertical projection]. (P99)
• The projector can be installed facing any direction*
, as shown
below. However, projection upward or downward may shorten the
useful life of the lamp. [Install settings] of the projector must also
be adjusted. Specifically, for upward or downward projection, refer
to instructions for [Vertical projection] (P99) in the [Install settings]
menu.
• Do not attempt to install the projector for upward or downward
projection by yourself. Always request installation by a qualified
technician or the Canon Customer Support Center.
*1 No optional accessories are available for installing the projector in
ways other than ceiling installation (P41, P199).
*2 An inclination of more than 10 degrees may damage the lamp.
Upward
projection:
Inclination of the
projector should
be no more than
10° from the
vertical axis.*
2
Downward
projection:
Inclination of the
projector should
be no more than
10° from the
vertical axis.
*
2
If installing the projector
on the floor or hanging
from the ceiling, the left /
right inclination of the
projector should be no
more than 10°.*
2
Do not use the
projector standing
on its side.
This may
damage the lamp.*
2
10°
10° 10°
10° 10°
10°
To Next Page
Loading...
Need help?
General
